Zebra Blinds Inc.
How to Install Zebra Blinds
A super simple guide for inside mount and outside mount. Follow the pictures and the 4 steps below.
Before You Start
Pencil, tape measure, drill or screwdriver, and level.
Inside the frame = Inside Mount. On the wall/trim = Outside Mount.
Both brackets must sit at the same height.
Inside Mount
The blind sits inside the window frame. For a clean built-in look, keep the front of the blind flush with the front edge of the trim.
Measure
Measure the inside width first, then the inside height.
Mark the brackets
Put one bracket near each top corner. Keep them near the front edge.
Screw them in
Hold the bracket in place and screw upward into the top of the frame.
Click in the blind
Hook the blind into the brackets, push until it clicks, then test it up and down.
Outside Mount
The blind sits on the wall or trim above the window. This gives more coverage and blocks more light.
Measure bigger
Measure the window, then add about 3 inches to the width and 3 inches to the height.
Mark the brackets
Hold the blind above the window and mark where each bracket will go.
Install brackets
Screw the brackets into solid wood or a stud. Use wall anchors if needed.
Click in the blind
Snap the blind into the brackets and test it.
Safety Chain Bracket
This is important for child safety.
Just mount the bracket, screw it in, and place the chain inside.
Easy Steps
- Step 1: Put the bracket where you want it.
- Step 2: Screw the bracket into the wall or window frame.
- Step 3: Put the chain inside the bracket.
- Step 4: Adjust the bracket so the chain is straight, but not too tight and not too loose.
Need Help?
If something does not look right, stop and contact Zebra Blinds Inc. before forcing the blind into place.
Contact Us